Factory EnvironmentaL gas Detection and Monitoring system
Gas Detection Solutions for factory environments
Manufacturing facilities and factories can have both safe and Hazardous areas. These are usually defined by the type of gas present, the concentration of the gas and also the ignition temperature of the gas. These areas are often designated as Ex areas, so in these areas it is very important to install the correct specification of equipment. Ex areas are generally split into 3 zones as below;
Zone 0 – Gas present all the time or for prolonged periods of time at potentially explosive levels, area usually categorised as Exia, meaning intrinsically safe equipment is required (More than 1000 hours per year)
Zone 1 – Gas is likely to be present in normal process conditions, area usually categorised as Ex, meaning explosion proof equipment is required (More than 10 hours per year but less than 1000 hours per year)
Zone 2 – Gas not likely to be present in normal process conditions, however if gas is detected it will only be brief periods of time, equipment in these areas are generally hermetically sealed and non sparking (Less than 10 hours per year)
Our factory environmental gas detectors have IECEx and ATEX compliance so you can be sure that our equipment complies with the appropriate AUS/NZ legislation according to the AS/NZS60079.10 Explosive Gas Atmosphere Classification.
Lift Shaft types Monitored
- Confined spaces
- Tanks
- Storage Voids
- Gas Station
- Marine
- Oil & Gas
- Petrochemical
- Sewage Treatment Plants
- Paint Manufacturers
- Chemical Plants
- Spraying Booths
- Aircraft Hangars
- Ammonia Refrigerant Systems
- Fertiliser Plants
Unique Solutions for Hazardous Areas
Factory environments may contain flammable liquids, solvents and toxic chemicals, it is important to monitor to ensure that the contaminants don’t emit alarm limits level gas concentrations. All our systems can be connected to the plants SCADA and DCS to allow continuous monitoring and allow historical logging. We as standard have multiple analog and digital outputs that can activate both visual and audible alarms i.e. beacons/sounders. We also have IECEx certification so you can be confident that we conform with all necessary legislation and regulations, so our sensors can be installed in Hazardous areas. We also have IECEx certification so you can be confident that we conform with all necessary legislation and regulations, so our sensors can be installed in Hazardous areas.
High accuracy in both Fixed and Portable detectors
Our fixed and portable gas sensors are accurate to 0.1% of the LEL / VOL scale, so you can be sure of reliability and timely indication of the gas presence reaching alarm limits. At which point you can relay the alarm condition via sounder / beacon, your internal AMS (Alarm Management System) or most other audio / visual warning equipment.
FACTORY ENVIRONMENTAL GAS Monitoring Systems Products
Site analysis and system engineering
Each project starts with consultation on our clients requirements. JWII then design a Gas Detection System to meet the project needs
Service and maintenance
Our service team can provide comprehensive field service as well as workshop repairs. We can also help you plan the maintenance of your devices with a periodic maintenance contract.
Site Installation
Our in house technical team can assist you in the installation and commissioning of your gas detection system. From physical mounting to connection and start up.
Calibration Services
Our calibration facility offers you peace of mind that your gas detection system is operating to specification. We can carry our field calibration as part of your service contract or in house calibration at our facility.
Discover all type of applications
We also have IECEx certification so you can be confident that we conform with all necessary legislation and regulations.
